完美世界国际版下载,小说阅读网站,手机推荐排行榜

BYD Forklift Operating Procedures- according to the instructions of the WCS (Warehouse Control System) warehouse control system Use both hands to push the control handle backward to between 0°-90° For specific classification, please refer to the previous two articles: [Forklift Knowledge] Forklift Classification (V): Class III Electric Transporter [Forklift Knowledge] Forklift Classification (VI): Class III Electric Stacker The third category vehicles are different from the second category vehicles

When loading and unloading goods, dragging the pallet on the ground will cause scratches on the ground

This is our current electric pallet truck

The forks can be tilted forward and backward following the hydraulic cylinder

Manual transport trucks are mainly used to transport pallets or directly transport goods Warehouse forklifts are widely used in the warehousing industry because of their compact body, flexible movement, light weight and good environmental performance

For a time, hydrogen fuel forklifts have become a new hot spot

Semi-electric stacking forklift refers to a wheeled transport vehicle that loads, unloads, stacks, and transports palletized goods over short distances

The forklift can only be moved with the current generated by the battery, and never with rectified AC to avoid damaging electronic components

Electric transport forklift manufacturers tell us that generally speaking, transfer forklifts can be divided into manual, semi-mechanical and fully electric

(20 Lower the fork to the lowest position so that there is no system pressure in the hydraulic system

If the temperature is significantly lower than -15℃, the engine system cannot be operated immediately after starting, but the engine should be run at 1000-1100r/min for 10-15min, and the transmission should be in a neutral position

For three-dimensional storage based on unmanned forklifts, the safety inspection is mainly considered from two aspects: the vehicle body itself and the loading device connected to the vehicle body

BYD Forklift Operating Procedures-

In 2019, Anhui Heli continued to deepen its electrification layout and invested 300 million yuan to build a "new energy vehicle and key parts construction project"

The forks of a battery truck are usually raised to a height of 200 MM, which is just enough to lift the pallet off the ground and keep a distance from the ground, allowing for free movement

When the ambient temperature is 40℃, the relative humidity should not exceed 50%

When putting down the load, the mast can be tilted forward slightly to facilitate placing the load and pulling out the fork

Maintenance-free: no need to add water, no pollution such as dripping, corrosion, etc

How to operate a new electric transporter How to use an electric transporter is not difficult, practice makes perfect

2 In the future, the three types of vehicles will have more configurations and development

Security As an industrial vehicle, safety is definitely something we need to pay attention to

The oil leaking from the crankshaft rear oil seal will enter the clutch, which will cause the clutch plate to slip or even burn

When the ambient temperature is 40℃, the relative humidity should not exceed 50%

However, since its development, electric forklifts have been subject to the bottleneck of batteries

BYD Forklift Operating Procedures-

It is forbidden to park the counterbalanced forklift in the moving area, and it is strictly forbidden to stand on the forks or pallets of the counterbalanced electric forklift

Fork deflection detection: When the fork is in the low position, measure the maximum deflection of the end corresponding to the maximum cantilever state under different loads If it is lower than the limited working voltage, the forklift should stop running immediately For example, for instruments with electric heating, waterproof connectors and electrical connector terminals are matched with rubber covers, and professional circuit routing is used to prevent water accumulation, so as to effectively deal with electrical faults caused by freezing and condensation

Due to the different properties of the fuel used by electric forklifts, electric forklifts can be divided into three types: the first is a forklift that is driven only by electrical energy (such as batteries, lithium batteries), that is, a pure electric forklift; the second is a hybrid forklift; the third is a forklift that is powered by a fuel cell (such as hydrogen fuel)

The uses of transport trucks produced by different manufacturers are different, which requires drivers to slowly adapt

■ Easier to operate Equipped with multi-disc parking and service brakes, the machine has better maneuverability

As for the third type of electric technology forklifts, they have not yet been put on the market in large quantities

What are they? Common power system failures are mainly manifested in failure to charge, charging voltage is too low, and charging voltage is too high Although the frame parts of the two forklifts are basically similar, diesel forklifts use engines and gearboxes as power sources, while battery forklifts use motors, gearboxes, batteries and controllers as basic power mechanisms

The application scenario guarantees the confidence of the product

Internal combustion: Internal combustion forklifts are divided into ordinary internal combustion forklifts, heavy-duty forklifts, container forklifts and side forklifts

BYD forklifts are equipped with lithium iron phosphate batteries independently developed by the company, which have set off a clean energy storm in the industry and become a symbol of the industry's new energy forklifts

欧美成人高清在线视频大全-欧美成人高清性色生活-欧美成人高清视频-欧美成人高清-在线观看欧美国产-在线观看男女爱视频网站

New energy forklift leader

Product

BYD Counterbalanced forklift

BYD Warehouse Forklift

BYD large tonnage forklift

BYD tractor truck

Core Features

High security

high performance

High efficiency

High Match

Low overall cost

Super fast charging

Ultra-long life

No charging room required

About Us

Product

BYD Forklift

Contact Info